How to properly set up SCG Smartboard

December 25, 2017

 " Let’s take a look at the step-by-step set up guide of each type of SCG Smartboard for a proper and quick installation.  

How to properly set up SCG Smartboard

Each type of Fiber Cement is a bit different from the others. Let’s take a look at the step-by-step set up guide of each type of SCG Smartboard for a proper and quick installation.

1. SCG Smartboard floors

Install SCG Smartboard floor on the steel joist with 1.2 - 3.2mm. thickness. Leaving about 30 - 40cm. of space in between.

Hold the SCG Smartboard panels together with SCG Self Drilling Screws 45mm., measuring 5cm. from the corners, leaving a space of 1.2 cm. from the borders, each point 20 cm. apart.

Use SCG Gumcrete to cover the connecting borders, leave until dry before installing the next floorboard.

2. SCG Smartboard Indoor Walls

et up the SCG Smartboard C47 and U79 Galvanize frame number 24, 0.55 mm. thick, leaving a space of not more than 60cm.

Then, glue the SCG Smartboard with the frame using SCG screws of 23mm. tip (ชนิดฝังหัวจม) without drilling in, measuring 5cm from the corner of the board, leaving a space of 1.2cm. from the borders, each point 20cm. apart.

For the slanted-border SCG Smartboard wall, seal the edges with SCG Plaster Cement Smartboard. For other types of indoor SCG Smartboard, seal the edges with SCG Polyurethane Smartboard glue. Leave them to completely dry before painting.

3. SCG Smartboard Exterior Walls

Install the C75 steel frame, 1.2 - 3.2mm. thick, leaving space of no more than 60cm.

Glue the SCG Smartboard wall with the frame with the SCG screw, the drilling tip with wings of 22mm. (ชนิดฝังหัวจม), measuring 5cm. from the corder of the board, leaving a space of 1.2cm. from the border, each point 20cm. apart.

Seal the edges with SCG Polyurethane Smartboard glue. Leave them to completely dry before painting.

4. SCG Smartboard Indoor Ceiling

Set up the galvanized steel frame number 24, 0.55mm. thick, leaving a space between the primary and secondary frame of 100cm. and 40cm., respectively. For the wooden frame, use 1.5 x 3 inches wood, leaving a space of no more than 60cm.

Glue the SCG Smartboard ceiling with SCG Screws, drilling tip of 23mm. (ชนิดฝังหัวจม), without prior drilling. For the wooden frame, nail 1 - 1.5 inches with wooden nails.

For the slanted-boarder SCG Smartboard ceiling, use SCG Acrylic Plaster to connect the edges. For other types of SCG Smartboard ceiling, use SCG Polyurethane Smartboard glue, leave to completely dry before continue painting.

5. SCG Smartboard Exterior Ceiling

Install wooden frame size 1.5 x 3 inches, spacing of not more than 60cm. apart.

Glue the SCG Smartboard ceiling with wooden nails of around 1 - 1.5 inches.

Glue the edges with SCG Polyurethane Smartboard glue, leave to completely dry before continue painting.

For a quick and convenient way of preparing the materials, if the contractor is not sure about the amount or the type of materials to use, they can consult our technical team or they can refer to the installation manual